3com WX1200 3CRWX120695A Manuel D’Utilisation

C

HAPTER

 5: C

ONFIGURING

 

AND

 M

ANAGING

 P

ORTS

 

AND

 VLAN

S

To configure a port group named server1 containing ports 1 through 5 
and enable the link, type the following command:

WX1200# set port-group name server1 1-5 mode on
success: change accepted.

After you configure a port group, you can use the port group name with 
commands that change Layer 2 configuration parameters to apply 
configuration changes to all ports in the port group. For example, 
Spanning Tree Protocol (STP) and VLAN membership changes affect the 
entire port group instead of individual ports. When you make Layer 2 
configuration changes, you can use a port group name in place of the 
port list. Ethernet port statistics continue to apply to individual ports, not 
to port groups.

To configure a port group named server2 containing ports 2 and 5 and 
add the ports to the default VLAN, type the following commands:

WX1200# set port-group name server2 2,5 mode on
success: change accepted.
WX1200# set vlan default port server2
success: change accepted.

To verify the configuration change, type the following command:

WX1200# display vlan config

Admin  VLAN  Tunl

 Port

VLAN Name

 Status State Affin Port

 Tag

State

---- ---------------- ------ ----- ----- ---------------- ----- -----

1 default

Up

  Up

5

server2

none

Up

4094 web-aaa          Up     Up        0
                                         2                 4094 Up

To indicate that the ports are configured as a port group, the display 
vlan config output lists the port group name instead of the individual 
port numbers.

To remove a port group, use the following command:

clear port-group name name