3com smart mobile stand for interactive displays fssbid 100h Manuel D’Utilisation

M O D E L   F S S B I D   1 0 0 :   C O N N E C T I N G   D E V I C E S   I N S I D E   Y O U R   S M A R T   M O B I L E  
S T A N D ’ S   C A B I N E T

99-00962-20 REV C0

3.

Connect the DB9 end of the SMART DB9 to USB adapter cable (included with 

your SMART Board for Flat-Panel Displays interactive overlay) to your pen tray, 

ensuring that you can still easily access the USB A plug at the other end.

–

First route this adapter cable through your SMART Mobile Stand’s 

connection panel and up

 

the prewired cable harness.

–

Leave some slack throughout the length of this cable. Don’t pull it tight.

–

Coil the excess cable and fasten it to the lower right clip on your 

SMART Mobile Stand’s speaker panel with plastic cable ties.

4.

Connect the USB plug that you left accessible in the previous step to the 

USB A receptacle of adapter AD09, which you purchased for your 

SMART Mobile Stand (as shown on page 32).

Don’t connect the SMART DB9 to USB adapter cable included with 

your SMART Board for Flat-Panel Displays interactive overlay to your 

computer, as instructed in the SMART Board for Flat-Panel Displays 

Installation Guide.

5.

If you’ve connected either a computer or a SMART Hub 

PE260 to your SMART Mobile Stand, remove the plastic 

cable tie from the USB B male cable (marked C04) in 

your SMART Mobile Stand’s prewired cable harness, and 

then connect it to the other end of the adapter 

that you purchased for your unit (as shown on page 32).

The other end of cable C04 is prewired to your 

SMART Mobile Stand’s connection panel.

Secure cable C04 to the SMART DB9 to USB adapter cable included 

with your interactive overlay with a plastic cable tie.

6.

Connect your interactive overlay’s power cable (included with your interactive 

overlay) to the right side of its power supply.