3com smart mobile stand for interactive displays fssbid 100h Manuel D’Utilisation

99-00962-20 REV C0

I M P O R T A N T   I N F O R M A T I O N

•

Make sure that the weight of your flat-panel display is minimum 

80 lb. (36.3 kg) and maximum 160 lb. (72.6 kg). For a list of flat-panel displays 

supported by your SMART Mobile Stand, see 

http://www2.smarttech.com/st/en-US/Support/FlatPanel/MobileStandPanels

.

•

To prevent damage to a 60" (152.4 cm) or larger flat-panel display when 

it is installed with a SMART Board for Flat-Panel Displays interactive overlay, 

make sure that you install the included clevis pin as instructed in this guide 

(see pag 13).

•

To prevent damage to your power and extender cables, secure them to your 

mobile floor stand as instructed in the SMART Mobile Stand for Interactive 

Displays Textless Installation Instructions (

at 

www.smarttech.com/support

).

•

To prevent crushing additional product cables between your flat-panel display 

and the SMART Mobile Stand’s speaker panel, follow the path of the installed 

cable harness.

•

Do not suspend additional objects from, or add any extra weight or excessive 

pressure to, your SMART Mobile Stand’s brackets (other than the products 

indicated in this guide). SMART designed these brackets to support only 

the combined weight of a flat-panel display, interactive overlay or display 

frame, laptop computer and optional laptop shelf, during normal use. 

Any other weight hung from these brackets may cause the stand to tip.

•

If you install additional audio or video cables other than those provided 

with your SMART Mobile Stand, SMART Board interactive display frame, 

SMART Board for Flat-Panel Displays interactive overlay, or as part of an 

adapter kit, SMART assumes no responsibility and you are solely responsible 

for any damage incurred to your SMART Mobile Stand, its cabling or 

other devices.

•

Your SMART Mobile Stand is designed for standard ramp access. At least two 

people are required to move your unit up or down a ramp. Moving your unit up 

or down a ramp with a steep incline may cause your SMART Mobile Stand to 

tip.

•

Never operate your SMART Mobile Stand immediately after moving it from a 

cold location to a warm location. Allow the unit to reach room temperature 

before operation to prevent possible product damage. The operating 

temperature range is from 41°F to 86°F (5°C to 30°C) with up to 80% relative 

humidity, non-condensing. The shipping and storage temperature range 

is from -40°F to 140°F (-40°C to 60°C).

•

Do not place your SMART Mobile Stand in hot locations, such as near 

heating equipment.