3com smart mobile stand for interactive displays fssbid 100h Manuel D’Utilisation

99-00962-20 REV C0

M O D E L   F S S B I D   1 0 0 H :   C O N N E C T I N G   D E V I C E S   I N S I D E   Y O U R   S M A R T   M O B I L E  
S T A N D ’ S   C A B I N E T

1.

Connect the VGA video plug from cable AV05 to your computer’s VGA 

video receptacle.

–

Your computer might have more than one VGA video receptacle. 

If this is the case, refer to the documentation included with your computer 

to determine the correct receptacle.

–

If your computer has only DVI receptacles, you likely received a DVI 

to VGA adapter (or video card) with your computer, which enables you 

to use the DVI connection. If you require a DVI to VGA adapter, you can 

usually purchase one from an electronics or computer store.

–

You previously connected the other end of this cable to your 

SMART Hub SE240 (see page 45).

2.

Connect the 3.5 mm stereo audio plug from cable AV05 to your computer’s audio 

output receptacle.

This audio receptacle is typically green, and is often marked with an insert 

arrow or the audio waves symbol 

. If you’re unable to locate this 

receptacle, refer to the documentation included with your computer for 

more information.

3.

Connect the USB A male plug of the USB A to USB B cable 

(not included) that you previously connected to your SMART Hub SE240 

to an available USB receptacle on your computer (see page 45).

4.

Connect your computer’s power cable (not included with your SMART Mobile 

Stand) to an available receptacle on your stand’s power bar.

Coil and bundle the cable with the included hook-and-loop fastener strap.