Arcam diva p80 Manuel D’Utilisation
A80/P80
10
A80/P80
11
POWER (and power indicator light)
2
Switches the unit on and off. The light indicates the status of the
amplifier.
When you switch your amplifier on, the light glows amber for a
few seconds, during which time the speakers are disconnected.
The light changes to green when the amplifier is ready for use. A
red light means the amplifier is in standby mode.
The light may flash if a fault has occurred somewhere in the
system (the fault type is shown on the front panel display of
the A80). You should unplug the amplifier and leave it for a few
minutes before reconnecting. If the fault cannot be cleared,
unplug your amplifier and contact your Arcam dealer.
amplifier.
When you switch your amplifier on, the light glows amber for a
few seconds, during which time the speakers are disconnected.
The light changes to green when the amplifier is ready for use. A
red light means the amplifier is in standby mode.
The light may flash if a fault has occurred somewhere in the
system (the fault type is shown on the front panel display of
the A80). You should unplug the amplifier and leave it for a few
minutes before reconnecting. If the fault cannot be cleared,
unplug your amplifier and contact your Arcam dealer.
Using your P80 power amplifier
A80 POWER AMPLIFIER
SP1
SP2
POWER
2
1
NOTE: If both lights are out the amplifier will appear not
to work, as all speakers are switched off. If both are on,
overloads are more likely if low impedance speakers are
connected.
to work, as all speakers are switched off. If both are on,
overloads are more likely if low impedance speakers are
connected.
SP1 and SP2
1
These buttons allow you to select and deselect the main
(
(
SP1
) and secondary (
SP2
) sets of speakers attached to your
amplifier.