ADC MM701F Manuel D’Utilisation

Page de 94
78
MM701F User Manual
community 
string
A text string required for an SNMP trap to be received by a trap receiver(s). Also, a 
text string that identifies an SNMP community and is associated with specific access 
rights (read-only or read/write).
CRC
Cyclic Redundancy Check is a method used to verify the accuracy of data 
transmission.
downstream 
traffic
Communications from a service provider to a user.
encapsulation
The inclusion of data in a protocol header prior to transmission, which enables 
successful data transmission between different protocol networks.
ES
Errored Seconds is the seconds during which errors occur that prevent the payload 
from being corrected.
Ethernet
A protocol used for LAN traffic, which has a transfer rate of 10 or 100 Mbps.
flash memory
Non-volatile memory that can be erased and reprogrammed.
gateway
A device (generally a router) that provides translation services to allow 
communication between two dissimilar networks.
IP
Internet Protocol is a TCP/IP protocol that controls packet transmission.
IP address
A 32-bit address used in IP routing. The address consists of four octets separated by 
decimals. The octets comprise a network section, a subnet section (optional) and a 
host section.
LAN
Local Area Network is a physically connected group of devices between which data 
transmission occurs at high speeds over relatively short distances.
LLC
Logical Link Control is an encapsulation protocol for data that you transmit from the 
modem over the WAN in 1483 Bridging/Routing mode.
LOF
Loss Of Frame is an error indicating that the receiving equipment has lost a frame.
LOS
Loss Of Signal is an error indicating that the receiving equipment has lost the signal.
MAC
Media Access Control is a physical address associated with a device such as a NIC. 
For modem configuration, the MAC is used to map inbound traffic (from a remote IP 
address) to an internal (LAN) IP address. Used with 1483 Bridging/Routing Mode.
margin
The noise margin in decibels that the modem must achieve with a BER of 10 
-7 
or 
better to successfully complete initialization.