HP 2000 Manuel D’Utilisation
7.
Disconnect the hard drive connector cable from the system board (see
8.
Remove the following components:
●
Keyboard (see
)
●
Top cover (see
●
USB board (see
●
Power connector cable (see
)
●
Display assembly (see
)
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
defective system board and installed on the replacement system board:
●
Memory module (see
)
●
RTC battery (see
●
Fan and heat sink (see
)
●
Processor (see
Remove the system board:
1.
Disconnect the optical drive connector cable from the system board.
2.
Remove the Phillips PM2.5×6.0 screw (1) that secures the system board to the base enclosure.
3.
Lift the right side of the system board (2) until it rests at an angle.
70
Chapter 4 Removal and replacement procedures