HP color laserjet 3000n Manuel D’Utilisation

ENWW

To set up the printer, complete the following steps. For illustrated setup 
information, see the setup poster. 

Select a location for the printer that is level, sturdy, and can support 
all corners of the printer, such as a low table. The location should 
be about 25 cm (10 inches) away from a wall to provide easy 
access to the rear of the printer for using Tray 1.

If your printer was shipped with Tray 3 or you purchased Tray 3 as 
an optional accessory, unpack Tray 3. Otherwise, go on to step 3.

Position Tray 3 in the location where you want to place 
the printer.

 b Remove the tape and packing materials from Tray 3, including 

the foam block located inside the tray.

Two people should lift the printer. Each person should grasp the 
printer in the front just under the lip below the LCD control panel, 
and in the rear by the indentation on either side of Tray 1. 
Alternately, each person can hold on to the bottom of the printer 
during lifting.

It is strongly recommended that two people lift or move the printer. 
The printer is top-heavy and can tip if lifted by only one person. 
The side of the printer that holds the ink cartridges and printheads 
is considerably heavier than the other side.

Do not attempt to move the printer by holding on to Tray 2 in the 
front or Tray 1 in the back. This can damage the printer and might 
cause you to lose your grip on the printer.

Move the printer to the prepared location. Be sure that the foam 
packing cushions are removed from the bottom of the printer. 
Gently place the printer on the prepared location.

-Or- 

If installing Tray 3, align the front edge of the printer with the 
front edge of the Tray 3 base. Gently lower the printer onto the 
Tray 3 base.