HP color laserjet 3800 Manuel D’Utilisation
Replace Supplies feature
The printer has three options for low or exhausted supplies status:
●
STOP AT OUT (the default setting): The printer continues printing while a print cartridge is low.
When the cartridge is out, the printer cannot print.
When the cartridge is out, the printer cannot print.
●
STOP AT LOW: The printer pauses until you replace the low cartridge.
●
OVERRIDE AT OUT: The printer continues printing even after some supplies have run out.
To set the Replace Supplies feature
1.
Press
Menu
.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight REPLACE SUPPLIES, and then press .
5.
Press
or
to select the appropriate setting, and then press to set the selection.
If you select OVERRIDE AT OUT and then press , a warning message appears. To accept
the override, select YES, USE OVERRIDE and press , and then set the page limit for the
override and press .
the override, select YES, USE OVERRIDE and press , and then set the page limit for the
override and press .
6.
Press
Menu
to return to the Ready state.
Jam Recovery feature
Use this option to configure the printer response to jams, including how it handles the pages
involved. AUTO is the default value.
involved. AUTO is the default value.
●
AUTO: The printer automatically turns jam recovery on when sufficient memory is available.
●
ON: The printer reprints any page involved in a jam. Additional memory is allocated to store the last
few pages printed. This might cause overall printer performance to suffer.
few pages printed. This might cause overall printer performance to suffer.
●
OFF: The printer does not reprint any page that was involved in a paper jam. Because no memory
is used to store the most recent pages, performance is optimal.
is used to store the most recent pages, performance is optimal.
To set the Jam Recovery feature
1.
Press
Menu
.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight JAM RECOVERY, and then press .
5.
Press
or
to select the appropriate setting, and then press to set the selection.
6.
Press
Menu
to return to the Ready state.
ENWW
Changing printer control-panel configuration settings
39