HP procurve 2500 Manuel D’Utilisation
231
Software Fixes
■
LACP —
Resolves several issues with LACP, including: conversation on a trunk may
momentarily fail if a trunk member port goes down, difficulty accessing the MIB, configura-
tion issues, port priority issues, problems with dynamic negotiation, and switch crashes with
messages similar to:
tion issues, port priority issues, problems with dynamic negotiation, and switch crashes with
messages similar to:
-> Software Exception at woody_dev.c: 450 in AdMgrCtrl
-> ppmgr_setDefaultPriority: invalid port number
-> ppmgr_setDefaultPriority: invalid port number
and
-> Software exception at woody_pktDriver.c:317 -- in 'eDrvPoll'
-> ERROR: ASIC buffer return failure
-> ERROR: ASIC buffer return failure
■
Link —
The switch exhibits intermittent link behavior when connected to some 3C905B
3Com NICs.
■
Monitor Port —
If a user attempts to monitor the monitoring port the switch displays a
meaningless error message.
■
Ping —
The switch replies to pings with a source address of 127.1.1.1, which is a loopback
address.
■
Port Security —
Static addresses are saved to startup-config without the user executing a
write memory
command. [Fix is: static addresses will only be saved to startup-config by
executing the
write memory command.]
■
SNMP —
For ports with no transceiver present, any SNMP sets to the
hpSwitchPortTable
fail
and an SNMP get of
hpSwitchPortType
,
hpSwitchStpPortType
, or
hpSwitchIgmpPortType2
returns an
illegal value of zero (0).
■
Stack Management —
Resolves several issues with ProCurve Stack Management via the
Web-browser interface, including problems with stacking configuration screen, Stack
Member port counters, and not being able to add a candidate to a stack.
Member port counters, and not being able to add a candidate to a stack.
■
STP —
Resolves several issues with STP, including problems with an SNMP set and get of
the
dot1dStpPortEnable
MIB variable, setting STP parameters via SNMP disables Spanning Tree,
and a switch crash with a message similar to:
-> Software exception at stp_ctrl.c:154 -- in 'mStpCtrl'
■
TFTP/XMODEM —
The switch's event log is not properly formatted when captured via
TFTP or XMODEM using the
copy
command.
■
VLAN —
After creating several VLANs, the default value for all ports in one VLAN is
forbid
and this value cannot be changed.
Release F.02.03
Fixed in release F.02.03:
■
Stack Management —
Cannot access member switches via SNMPv2c.