Juniper CBL-PWR-10AC-STR-IT Manuel D’Utilisation
Installing the M7i Fan Tray
To install the fan tray (see
CAUTION:
When sliding the fan tray into the chassis, make sure your fingers
are not near the fans, which start spinning as soon as the fan tray contacts
the midplane.
the midplane.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
2.
Grasp the sides of the fan tray and align the rear of the tray with the guides inside the
chassis.
chassis.
3.
Slide the fan tray all the way into the chassis.
NOTE:
Use the fan tray handle to slide the fan tray into the chassis. Do
not push on the fan tray faceplate.
4.
Tighten the thumbscrew on the fan tray.
Figure 58: Installing the Fan Tray
Related
Documentation
•
•
•
123
Copyright © 2012, Juniper Networks, Inc.
Chapter 15: Replacing M7i Hardware Components