Canon multipass c5500 Manuel D’Utilisation

Page de 332
10-8
Troubleshooting
Chapter 10
Message
Error Code
Cause
Action
DIALING
The MultiPASS is
Press 
STOP
if you 
dialing the receiving 
want to cancel the 
fax machine.
transmission.
DOC TOO LONG
#003
It took more than 32
Divide the document 
minutes to send or 
and send or copy each 
copy a document.
part separately.
It took more than 32
Contact the other party.
minutes to receive a
Have them divide the
document.
document and send 
each part separately.
The document is longer
Use a copy machine to
than 39.4 inches (1 m).
make a reduced copy of
the document and send
the copy.
DOCUMENT READY
The document in the
Send the fax, scan the 
ADF is ready for faxing,
document, or make the
scanning, or copying.
copy.
ECM RX
The MultiPASS is
ECM transmissions may
receiving a fax 
take longer than normal
using ECM.
transmissions. Turn
off ECM if you need to
receive quickly, or if you
know your local lines
are in good condition.
ECM TX
The MultiPASS is
ECM transmissions may
sending a fax using 
take longer than normal
ECM.
transmissions. Turn off
ECM if you need to 
transmit quickly, or if
you know your local
lines are in good
condition.
HANG UP PHONE
The telephone is 
Place the telephone
off hook.
properly into its cradle.
INSTALL BC-20/21
The BC-22e or BC-29F
Remove the BC-22e or 
BJ Cartridge is installed,
BC-29F BJ Cartridge
so the MultiPASS cannot and install the BC-21e
print any received faxes,
or BC-20 BJ Cartridge.
or make copies.
INSTALL BC-21
The BC-20, BC-22e,
Remove the BC-20,
or BC-29F BJ Cartridge
BC-22e, or BC-29F 
is installed.
BJ Cartridge and install
the BC-21e BJ Cartridge.
LOAD PAPER
The MultiPASS is out
Load paper in the sheet
of paper (the sheet
feeder. Make sure the
feeder is empty).
stack does not exceed
the limit mark. Then 
press 
START/COPY
.