Canon pixma mp180 Manuel D’Utilisation
88
Chapter 10
Troubleshooting
Cannot See The Display On The LCD/LED
E, 1, 4
The FINE Cartridge may not be the compatible with this machine. Install
the appropriate FINE Cartridge. If lines are misaligned or the resulting
output is not satisfactory, carry out the FINE Cartridge Alignment.
the appropriate FINE Cartridge. If lines are misaligned or the resulting
output is not satisfactory, carry out the FINE Cartridge Alignment.
E, 1, 5
FINE Cartridge errors have occurred. Replace the FINE Cartridge.
E, 1, 6
This FINE Cartridge may have previously been used, or the ink may have
run out. The function for detecting the remaining ink level will be disabled
since the remaining ink level cannot be correctly detected. If you want to
continue printing without this function, press [Black] or [Color]. Canon
recommends to use new genuine Canon Cartridges in order to obtain
optimum qualities.
run out. The function for detecting the remaining ink level will be disabled
since the remaining ink level cannot be correctly detected. If you want to
continue printing without this function, press [Black] or [Color]. Canon
recommends to use new genuine Canon Cartridges in order to obtain
optimum qualities.
E, 1, 9
The size of the document cannot be correctly detected or the document is
too small when the Fit-to-Page copying is selected. Make sure the
document meets the requirements and correctly loaded on the Platen
Glass. Then reload the document and press [Black] or [Color]. See
“Setting Documents” on page 15.
too small when the Fit-to-Page copying is selected. Make sure the
document meets the requirements and correctly loaded on the Platen
Glass. Then reload the document and press [Black] or [Color]. See
“Setting Documents” on page 15.
E, 2, x
E, 3, x
E, 4, x
E, 3, x
E, 4, x
An error requiring servicing might have occurred. Turn OFF the machine,
and unplug the power cord of the machine from the power supply. After a
while, plug the power cord of the machine back in and turn ON the
machine. If the same error occurs, contact a Canon service representative.
and unplug the power cord of the machine from the power supply. After a
while, plug the power cord of the machine back in and turn ON the
machine. If the same error occurs, contact a Canon service representative.
Cause
Action
The Machine is not turned ON.
You have not pressed [ON/OFF].
The machine will power ON and the LCD/LED will display a message when
you connect the power cord and press [ON/OFF].
The machine will power ON and the LCD/LED will display a message when
you connect the power cord and press [ON/OFF].
The LCD/LED may be in the Power
Saver mode.
Saver mode.
Press any button on the Operation Panel except for [ON/OFF] to restore
the display.
the display.
Message
Action