Canon pixma mp500
Chapter 9
87
Changing the Machine Settings
Read/write attribute
Selects whether to allow data to be written onto memory cards from a computer.
Power save setting
The LCD goes out if the machine is not operated for 5 minutes. Press any button on the
Operation Panel except for [ON/OFF] to restore the display.
Operation Panel except for [ON/OFF] to restore the display.
Even though you can select from <5 minutes>, <15 minutes>, <1 hour>, or <8 hours> as the
time until power save starts, the actual time until power save starts does not change.
time until power save starts, the actual time until power save starts does not change.
Adjust contrast
Use this to adjust the contrast of the LCD if it is too low or too high.
Slide show setting
Specifies the image display quality of the slide show.
Language selection
Changes the language for LCD messages.
Reset setting
You can change the settings back to the default, except for the language for LCD messages and the
position of the Print Head.
position of the Print Head.
Save settings
Saves the settings for the Settings screen.
Load settings
Loads the settings for the Settings screen that were saved.
Important
If you set this setting to <Read/write mode>, card direct printing cannot be
done. After you finish operation of the memory card dedicated drive, be
sure to revert this setting to <Read-only mode>.
done. After you finish operation of the memory card dedicated drive, be
sure to revert this setting to <Read-only mode>.
Note
When <Image quality: Std> is selected, images are displayed at 5-second
intervals. When <Image quality: High> is selected, images are displayed
at different time intervals according to their resolutions.
intervals. When <Image quality: High> is selected, images are displayed
at different time intervals according to their resolutions.