Samsung bd-7181w Manuel D’Utilisation

16

17

1.

Once the cuff is properly applied and you are seated with your  
feet flat on the floor you are ready to take a measurement.

2.

Press the

(Up) or 

(Down)  button  

and you will see a number appear: 1,2, or  
3. These are each of the 3 party memory  
zones explained on page 9 (Special  
Features).

*If you select zone No. 1 your blood  

pressure will be recorded as one of the 30 readings available  

for that zone. The same is true for zones 2 and 3. When taking  
measurements, be sure and select the correct zone number so  

that the measurement is stored in the appropriate zone.

3.

Press the START/STOP button. The monitor will begin to  

inflate to the level that's right for you. An upwards facing  
arrow on the digital display indicates the monitor is inflating.  
Remain still and do not talk during the measurement process.

4.

You will feel the cuff get tighter around  
your arm - this is normal. It should not  
inflate to the point of discomfort. If this  
occurs, the cuff may be secured too tightly.  
To  stop the inflation, press START/STOP.  
The cuff will deflate automatically. Rewrap  
the cuff allowing more room between your  
arm and the cuff.

Inflation

1.If your arm measures 9"-13" around, use the 

regular cuff included with your monitor. If your 
arm measures 13"-17" around, please use a 
Walgreens Large Cuff (Model #BC-200W).

2.Before taking a measurement, read the Important 

Reminders on pages 14-15. Make certain the cuff 
plug is inserted securely in the monitor and the 
cuff is assembled properly. Remove any 
constricting or thick clothing from your upper arm. 

3.Slide your arm through the cuff loop. The cuff 

should be positioned on your bicep about 1/2" 
above the elbow. With your palm facing up, the 
red arterial marker should be in the center of your 
arm over the brachial artery. The cuff tube should 
run down the center of your arm. Instructions are 
also printed on the cuff for reference. 

4.Secure the cuff around your arm using the velcro 

so it fits securely but is not too tight. You should 
be able to place 2 fingers in between the cuff 
and your arm. 

5.The velcro tab should fall within the "OK" range 

printed on the cuff for proper use. If your arm is 
larger than 13" around and the cuff does not fall 
within the "OK" range, please use a Walgreens 
Large Cuff (Model #BC-200W). 

6.Relax your arm and place your elbow on the 

table.

..

..........................

/STOP

MEMORY

mmHg

MEMOR

Y

ST

AR

T/ST

OP