Samsung dc68-01518q Manuel D’Utilisation

1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise 

and pull out the filter. 

3. Remove dirts and rotate 

the filter clockwise 
until it locks in position.

(pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the filter-cap to the left.
3.Take the filter out and 

remove dirts.

4. Reassemble in 

reverse order.

•  

When a proper amount (one time does) of fabric

softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.

•  

Do not use detergent, bleach or starch into 
the Softener Inlet.

•  

Using too much softener may produce 
unsatisfactory results.

•  

Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.

•  

Do not leave the softener 
into the Softener 
Dispenser for a long time. 
Because softner 
became stiff.

Clean the filter net often to keep the washer clean.

1. Push the upper part

of the filter and pull in.

2. Open the cover as 

shown in the figure.

3. Clean the filter.

4. Close the cover and insert the 

lower part of the filter in the 
basket first and then push the 
filter with "click" sound .

1. Push up and 

pull out the filter net.

2. Remove the collected

lint from the filter net.

3. Clean the filter.

4.  Pull down the filter net.

1.Open the detergent box by pulling in the direction of the arrow as shown in the 

figure and then put the powder detergent in the detergent box.

2. Put in one-time amount of detergent  evenly so the detergent  may not brim over the box.

Detergent Device
Put the detergent 

in proportion to 

water level

CAUTION : If softener is stored over the above base line, it may flow down at any time.

Softener 

baseline

gb-ar-8kg-01518Q  6/5/02 1:22 PM  Page 10