Juniper CBL-PWR-10AC-STR-AU Manuel D’Utilisation
Removing the CompactFlash Card from a Routing Engine
The CompactFlash card is located inside the Routing Engine. To remove the CompactFlash
card (see
card (see
):
1.
Place an electrostatic bag or antistatic mat on a flat, stable surface.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
3.
Remove the Routing Engine as described in
.
4.
Use needlenose pliers with grooved jaws to pull the wire clasp out from under the
CompactFlash card and lift it up (see
CompactFlash card and lift it up (see
).
5.
Use the needlenose pliers to gently grasp the CompactFlash card and slide it out of
the connector. Place the CompactFlash card on the antistatic mat or in the electrostatic
bag.
the connector. Place the CompactFlash card on the antistatic mat or in the electrostatic
bag.
Figure 46: Removing the CompactFlash Card
Routing Engine (front)
Wire clasp
CompactFlash card
g003214
Inserting the CompactFlash Card
To install the CompactFlash card (see
):
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
2.
If the CompactFlash card is in a PCMCIA card adapter, slide it out of the adapter.
3.
Slide the CompactFlash card into the connector on the Routing Engine (see
).
4.
Use needlenose pliers with grooved jaws to lower and secure the wire clasp.
5.
Install the Routing Engine as described in
Copyright © 2012, Juniper Networks, Inc.
106
M7i Multiservice Edge Router Hardware Guide