Samsung bixolon srp-275 Manuel D’Utilisation

 

 

 

 

 

1 Upside 

down 

On 

Off 

2 

Font Selection 

Font B 

Font A 

3 

Selection Paper End Buzzer 

Off 

On 

4 

Reserved 

Fixed to Off 

5 

Selection of the cover open status 

Cover open 

Paper end 

6 

Buffer Size 

40 bytes 

8 Kbytes 

7 

Receive buffer full release 

Remaining 522 bytes 

Remaining 640 bytes 

8 

Printer (Cover open during operation) 

Errors that can 
possibly recover 

Errors that 
automatically recover 

 

  NOTES 

When Off is selected, a bit of the “paper end sensor” in each status that is transmitted from the printer is 
changed every time the rear cover is open or closed. When On is selected, a bit of the “rear cover open / 

close" in each status that is transmitted from the printer is changed every time the rear cover is open or 

closed. When you replace a SRP-270 with a SRP-275, you should adjust the MSW 8-5 to Off. 
MSW 8-8: 
When Off is selected, a bit of the “automatic recoverable error” in each status that is transmitted from 

the printer is changed every time the rear cover is open. When On is selected, a bit of the “mechanical 

error” in each status that is transmitted from the printer is changed every time the rear cover is open. 
The setting of MSW 8-5 and 8-8 can be set by “Memory Switch setup mode”. 

 

 

Paper roll width 

57.5 mm / 69.5 mm / 76 mm (default value) 

 

  NOTES 

These setting can be set by “Memory Switch setup mode.” 

 

 

 

2400 bps 

4800 bps 

baud rate 

9600 bps 

19200 bps 

None Odd 

Parity 

Even - 

Handshake DSR/DTR 

XON/XOFF 

Data length 

7 bit 

8 bit 

 

  NOTES 

There are two methods, DIP Switch and Memory Switch, to adjust the serial communication conditions. 

DIP Switch 1-5 selects which is effective, DIP Switch or Memory Switch. 
To enable the “Serial communication“ setting, you have to adjust the “Serial interface selection“ function 

of DIP Switch 1-5 to “Memory Switch”. 

These settings can be set by “Memory Switch setup mode”.