Samsung sw68asp Manuel D’Utilisation

5

Clean the filter net often to keep the washer clean.

1.  Place a rag under washer filter not to wet the floor.
2.  Turn the filter-cap to the left.
3.  Take out the filter and remove any sludge.
4.  Reassemble in reverse order.

1.  Open the detergent box  

by pulling in the direction of the  
arrow as shown in the figure.

2.  Add the amount of detergent for one  

washing evenly in the box so that the 
detergent does not overflow the box.

1.  Pull down the adjusting handles of 

the adjusting feet which are located 
at the right and left of the front side. 

2.  Adjust the height of the  

machine upwards or downwards.

3.  When the adjustment is finished, 

push back the handles to fix the  
adjusting feet. 

Note
Do not kick or step on the adjusting  
handles.

  When a proper amount of fabric softener is stored 

in the box, it is automatically added in at the 
final rinse cycle.

  In case the hot water only is connected,  

this function will not be operated. 

  When too much softener is stored above the  

base line, it may  not be operated properly.

  Open the lid of the machine, pour water into the tub 

up to the level just below the pulsator, and adjust the 
legs so that the pulsator is positioned at the center of 
the water as shown in the figure.

  Place the machine more than 10cm away from the 

wall.

1.  Push the upper 

part of the filter 
and pull in.

2.  Open the cover  

as shown in the  
figure.

3. Clean the filter. 4.  Close the cover and 

insert the lower part  
of the filter in the 
basket first and then 
push the filter with 
"click" sound .

SW68ASP-02290A-EN.indd   5

2006-08-21   ¿ÀÈÄ 8:33:13