Samsung we357a7g Manuel D’Utilisation

Page de 28
Installing your washer
 
_7
Grounding
ELECTRICAL GROUNDING IS REQUIRED ON THIS APPLIANCE.
This appliance must be grounded. In the event of malfunction or breakdown, grounding will 
reduce the risk of electric shock by providing a path of least resistance for electric current.
This appliance is equipped with a power cord having a three-prong grounding plug for use in a 
properly installed and grounded outlet.
Improper connection of the equipment-grounding conductor can result in a risk of electrical 
shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the 
appliance is properly grounded. Do not modify the plug provided with the appliance – if it 
does not fit the outlet, have a proper outlet installed by a qualified electrician.
IMPORTANT SAFETY PRECAUTIONS
•  To prevent unnecessary risk of fire, electrical shock or personal injury, all wiring and 
grounding must be done in accordance with the National Electrical Code ANSI/FNPA, No. 
70 Latest Revision and local codes and ordinances. It is the personal responsibility of the 
appliance owner to provide adequate electrical service for this appliance.
NEVER CONNECT GROUND WIRE TO PLASTIC PLUMBING LINES, GAS LINES, OR HOT 
WATER PIPES.
Water
To correctly fill your Washer in the proper amount of time, water pressure of 20 – 120 psi is 
required.
Water pressure less than 20 psi may cause water valve failure, not allowing the water valve 
to shut off completely. Or, it may extend the fill time beyond what your Washer controls allow, 
resulting in your Washer turning off. A time limit is built into the controls in the event of an internal 
hose becoming loose and flooding your home.
The water faucets must be within 4 feet/122cm of the back of your Washer for the inlet hoses 
provided with your Washer.
Accessory inlet hoses are available in various lengths up to 10 feet/305cm for faucets that 
are further away from the back of your Washer.
To avoid the possibility of water damage:
•  Have water faucets easily accessible
•  Turn off faucets when the washer is not in use.
•  Periodically check that there is no leakage from the water inlet hose fittings.
CHECK ALL CONNECTIONS AT THE WATER VALVE AND FAUCET FOR LEAKS.
Drain facility
The recommended height of the standpipe is 18 in/46 cm. The drain hose must be routed 
through the drain hose clip to the standpipe. The standpipe must be large enough to accept the 
outside diameter of the drain hose. The drain hose is attached at the factory.
01 Installing your washer
CAUTION
WARNING
WARNING
WF337A-02440A-05_EN.indd   7
2007-04-17   ø¿»ƒ 1:53:20