Sony CMT-SE9 Manuel D’Utilisation
50
GB
Before you start editing
You can edit an MD only when:
• The MD is recordable.
• The MD play mode is Normal Play.
Check the following, before editing.
Check the following, before editing.
1
Check the tab of the MD to be edited.
Slide the tab to close the slot.
If the MD is protected, you cannot edit the
MD.
MD.
2
Press PLAY MODE repeatedly until
both “SHUF” and “PGM” disappear.
both “SHUF” and “PGM” disappear.
You can edit the MD only in Normal Play
mode. You cannot edit the MD in Shuffle or
Program Play mode.
mode. You cannot edit the MD in Shuffle or
Program Play mode.
To quit while editing
Press MENU/NO.
After editing
Press
Z
MD on the MD deck to remove the
MD or press
?/1
(power) to turn off the
system.
“TOC” starts flashing. The TOC is updated and
editing is completed.
editing is completed.
Before pulling out the mains lead
MD editing is completed when the MD Table of
Contents (TOC) is updated. The TOC is updated
when you eject the MD or press
Contents (TOC) is updated. The TOC is updated
when you eject the MD or press
?/1
to turn off
the system. Do not pull out the mains lead before
updating the TOC or while updating the TOC
(while “TOC” lights up or flashes) to ensure a
complete editing.
updating the TOC or while updating the TOC
(while “TOC” lights up or flashes) to ensure a
complete editing.
Notes
• You cannot edit the MD during MD-TAPE Synchro
Recording.
• If you edit an MD while manually recording the MD
to a tape, the sound (rehearsal sound, etc.) produced
during the editing is recorded on the tape.
during the editing is recorded on the tape.
What is the Group Function?
The Group Function allows you to play, record
and edit the tracks on an MD in groups. For
example, you can register tracks 1 to 5 on an MD
to the “Rock” group, and tracks 6 to 9 to the
“Pops” group. Then you can listen to the tracks
in only the desired group, add new tracks to a
group, and perform other operations. In
addition, the Group Function can be easily
turned on and off simply by pressing MD
GROUP.
and edit the tracks on an MD in groups. For
example, you can register tracks 1 to 5 on an MD
to the “Rock” group, and tracks 6 to 9 to the
“Pops” group. Then you can listen to the tracks
in only the desired group, add new tracks to a
group, and perform other operations. In
addition, the Group Function can be easily
turned on and off simply by pressing MD
GROUP.
When the group function is turned on, track
numbers within groups are renumbered, starting
from track 1. In the above figure, for example,
tracks 4 to 7 are renumbered to 1 to 4 when the
group function is turned on.
numbers within groups are renumbered, starting
from track 1. In the above figure, for example,
tracks 4 to 7 are renumbered to 1 to 4 when the
group function is turned on.
MD – Editing
Editing tips
Registering tracks in
groups
groups
— Group Function
1 2 3 4 5 6 7
1 2 3
1 2 3 4
MD
Track name
MD
Track name
Track name
Group 1
Group 2
Group Function: Off
Group Function: On