Sony ht ddw1600 Manuel D’Utilisation

Before using the receiver for the first time, 
initialize the receiver by performing the 
following procedure. This procedure can also 
be used to return settings you have made to 
their factory defaults. 
Be sure to use the buttons on the receiver for 
this operation.

Press ?/1 to turn off the 
receiver.

Hold down ?/1 for 5 seconds.

“PUSH” and “ENTER” appears on the 
display alternately.

After “CLEARING” appears on the 
display for a while, “CLEARED” 
appears.
The following items are reset to their 
factory settings.
• All settings in the LEVEL, TONE, 

SUR, TUNER, AUDIO, VIDEO and 
SYSTEM menus.

• The sound field memorized for each 

input and preset station.

• All sound field parameters.
• All preset stations.
• All index names for inputs and preset 

stations.

• MASTER VOLUME is set to “VOL 

MIN”.

• Input is set to “DVD”.

Insert two R6 (size-AA) batteries in the 

 

RM-AAU013 (models of area code MX, E51, 
AR only) or RM-AAU015 (models of area 
code SP, AU, TH only) remote commander.
Observe the correct polarity when installing 
batteries.

• Do not leave the remote in an extremely hot or 

humid place.

• Do not use a new battery with old ones.
• Do not mix alkaline batteries and other kinds of 

batteries.

• Do not expose the remote sensor to direct sunlight 

or lighting apparatuses. Doing so may cause a 
malfunction.

• If you do not intend to use the remote for an 

extended period of time, remove the batteries to 
avoid possible damage from battery leakage and 
corrosion.

• When you replace the batteries, the remote buttons 

may be reset to their factory settings. If this 
happens, reassign the buttons again (page 69).

Under normal conditions, the batteries should last 
for about 3 months. When the remote no longer 
operates the receiver, replace all the batteries with 
new ones.

?/1