Sony LPR-1000MD Manuel D’Utilisation

Mi
sc
el

la

ne
ou
s

Precautions

50

• Operate the printer using the power source specified in 

“Specifications” on page 59.

• Be careful not to damage the AC power cord by 

placing or dropping heavy objects on it; it is dangerous 
to use the printer with a damaged AC power cord.

• If you do not intend to use the printer for a long time, 

disconnect the AC power cord.

• Unplug the AC power cord by grasping the plug, not 

the cable itself.

• Do not disassemble the printer.
• Do not remove the cover. There is a danger of electric 

shock from the internal parts.

• Be careful not to spill water or other liquids on the 

printer, or to allow combustible or metallic material to 
enter the cabinet. If used with foreign matter in the 
cabinet, the printer is liable to fail, or present a risk of 
fire or electric shock.

• Ventilation holes are provided to prevent the printer 

from overheating. Be careful not to obstruct them with 
other printers or by covering the printer with a cloth, 
etc.

• If the printer malfunctions or if a foreign body falls 

into the cabinet, disconnect the AC power cord 
immediately and consult your dealer.

When handling the printer for assembly and so on, pay 
attention to the following:
• The printer is heavy. When lifting the printer, be 

careful not to hurt your back.

• When lifting the printer, put your hands under the 

bottom of the printer from both sides and pick it up 
horizontally.

• Be sure not to lift the printer by paper outlet or head 

cover. If you do so, these parts may break, or the 
printer may fall and this may cause injury.

• When putting the printer down, put the back feet of the 

printer first, and then put the front feet down slowly.

The printer is a precision instrument which contains 
liquid ink. 
• Place the printer in a location which meets the 

following conditions:
– 10°C to 35°C (50°F to 95°F) temperature and 20 to 

80% humidity

– horizontal (within ±2.0°) and stable

• If you place the printer on a slanted surface, the printer 

may not print correctly because the ink will spray out 
at an angle. 

• To protect the printer from damage, place it:

– Away from slippery surfaces
– Away from mechanical vibration
– Away from excessive dust
– Away from extremely hot or cold wind
– Away from direct or excessive sunlight
– Away from water or other liquids.
– Do not cover the printer with a cloth, etc. and place 

it in a location with good ventilation.

• Place the printer so that the four feet of the printer are 

on a flat surface. If you place the printer at a slant, the 
paper may not feed correctly.