Sony LPR-1000MD Manuel D’Utilisation
In
tr
od
uc
tio
n
uc
tio
n
Location and Function of Parts and Controls
8
D Head cartridge lock screws (three positions)
Used to lock the head cartridge. Do not move these
screws from the lock position.
screws from the lock position.
E Ink cartridge holder (43)
One black ink cartridge holder and one gray ink
cartridge holder are attached. If one of them runs
out, the printer cannot print.
Use the following ink cartridges for replacing.
Black: EPI-L100BL Sony Ink Cartridge
Gray:EPI-L100GL Sony Ink Cartridge
cartridge holder are attached. If one of them runs
out, the printer cannot print.
Use the following ink cartridges for replacing.
Black: EPI-L100BL Sony Ink Cartridge
Gray:EPI-L100GL Sony Ink Cartridge
Rear
A
USB connector (60)
Connects the supplied USB cable.
B Ventilation holes (51)
Provided to prevent the printer from overheating.
C Equipotential ground terminal connector
Used to connect the unit to the equipotential plug of
peripheral equipment to bring the various parts of
the system to the same potential.
Refer to “Important safeguards/notices for use in
the medical environments” on page 2.
peripheral equipment to bring the various parts of
the system to the same potential.
Refer to “Important safeguards/notices for use in
the medical environments” on page 2.
D -AC IN connector
Used to connect the printer to a wall outlet with a
power cable.
Refer to “Warning on power connection” on page 3
and “Warning on power connection for medical
use” on page 3.
power cable.
Refer to “Warning on power connection” on page 3
and “Warning on power connection for medical
use” on page 3.
E Main power switch (9)
This is the main power switch of the printer. Used
to turn the printer on or off. When this switch is set
to turn the printer on or off. When this switch is set
to on, the power to the printer is on when the ON/
STANDBY button on the front panel is set to on.
STANDBY button on the front panel is set to on.
Note on turning the main power off
The printer may automatically perform
maintenance operations when print operations are
not being performed. Also, when the printer is set to
standby mode by pushing the ON/STANDBY
button, the printer may also automatically perform
maintenance tasks so that the printer will work
properly when the power is turned on again. After
this maintenance is performed, the printer is reset to
standby mode. During maintenance, the READY
indicator blinks and the printer moves to the
standby mode after completing the maintenance.
Before turning the main power off, be sure to set the
printer to the standby mode by pushing the ON/
STANDBY button, and then set the main power
switch to off.
The printer may automatically perform
maintenance operations when print operations are
not being performed. Also, when the printer is set to
standby mode by pushing the ON/STANDBY
button, the printer may also automatically perform
maintenance tasks so that the printer will work
properly when the power is turned on again. After
this maintenance is performed, the printer is reset to
standby mode. During maintenance, the READY
indicator blinks and the printer moves to the
standby mode after completing the maintenance.
Before turning the main power off, be sure to set the
printer to the standby mode by pushing the ON/
STANDBY button, and then set the main power
switch to off.