Sony PCLK-MN10A Manuel D’Utilisation
5
GB
System requirements
The following hardware and software are necessary to use the M-crew
(ver. 1.05E) software.
(ver. 1.05E) software.
s
IBM PC/AT or compatible (This software does not run on the Apple
Macintosh.)
Macintosh.)
s
CPU*
1
:
Intel Pentium II 233 MHz/Celeron 300A or higher
s
Video board and display driver:
VGA (800
×
600 pixels), 65,536 colors or more.
s
Hard disk space: 20 MB*
2
or more (When installing both M-crew
and on-line manual.)
s
CD-ROM drive*
3
s
USB port:
1 or more
s
OS:
Windows 98/Windows 98SE/Windows 2000/
Windows Me (This software does not run on
Microsoft Windows 3.1, Windows 95 or Windows
NT.)
Windows Me (This software does not run on
Microsoft Windows 3.1, Windows 95 or Windows
NT.)
s
Media player:
Windows Media Player (Before you can use the
M-crew software, you must first install Windows
Media Player (version 6.4 or higher) into your
computer.)
M-crew software, you must first install Windows
Media Player (version 6.4 or higher) into your
computer.)
s
Video monitor:
VGA (800
×
600 pixels), 65,536 colors or more.
*
1
The operation of M-crew is not guaranteed on some computers with Pentium-
compatible CPU chips, such as the AMD K6 (e.g., sound skipping may occur
during playing of an audio file).
compatible CPU chips, such as the AMD K6 (e.g., sound skipping may occur
during playing of an audio file).
*
2
Another 15 MB of hard disk space is required to install PictureGear Label
Maker.
Maker.
*
3
If your CD-ROM drive is connected to your computer through a SCSI
controller (including PCMCIA card type), you will be able to install the M-
crew software, but you will not be able to play an audio CD in the CD-ROM
drive.
controller (including PCMCIA card type), you will be able to install the M-
crew software, but you will not be able to play an audio CD in the CD-ROM
drive.
Note
The PC LINK connector is not compatible with a CONTROL A 1 or A 1 II, or
CONTROL I connector. If your system stereo has a CONTROL A 1 or A 1 II
connector, you must use the PCLK-MD2 Connecting Kit (not supplied).
CONTROL I connector. If your system stereo has a CONTROL A 1 or A 1 II
connector, you must use the PCLK-MD2 Connecting Kit (not supplied).