Sony rdr-gx700 Manuel D’Utilisation

Page de 116
101
Addi
tion
al
 I
n
fo
rm
at
io
n
Others
The recorder does not operate properly.
, Restart the recorder. Press down [/1 on the 
recorder for more than ten seconds until 
“WELCOME” appears in the front panel display.
, When static electricity, etc., causes the recorder 
to operate abnormally, turn off the recorder and 
wait until the clock appears in the front panel 
display. Then, unplug the recorder and after 
leaving it off for a while, plug it in again.
Five numbers or letters are displayed in the 
front panel display.
, The self-diagnosis function was activated (see 
the table on page 102).
The disc tray does not open after you press Z 
(open/close).
, It may take a few seconds for the disc tray to 
open after you have recorded or edited a disc. 
This is because the recorder is adding disc data to 
the disc.
The disc tray does not open and “TRAY 
LOCKED” appears in the front panel display.
, Contact your Sony dealer or local authorized 
Sony service facility.
“RECOVERY” appears in the front panel 
display.
, The recorder’s recovery function was activated 
when the recorder was turned on because the 
power was turned off or failed during recording. 
Leave the recorder on until “RECOVERY” 
disappears from the front panel display.
“FAN ERROR” appears in the front panel 
display.
, Check that the vent on the rear of the recorder is 
not blocked. Then, turn off the recorder, wait 
until the clock appears in the front panel display, 
and disconnect the mains lead. Leave the 
recorder off for a while, then re-connect the 
mains lead, and press [/1 on the recorder.
Mechanical sound is heard when the recorder 
is off.
, While the recorder is adjusting the clock for the 
Auto Clock Set function or scanning the 
channels for the PDC/VPS function, operational 
noises (such as the internal fan) may be heard, 
even when the power is off. This is not a 
malfunction.
The disc tray does not open and you cannot 
remove the disc after you press 
Z (open/
close).
, Turn off the recorder. Once the clock appears in 
the front panel display, disconnect the mains 
lead. Connect it again while pressing down A on 
the recorder, and release the button when the disc 
tray opens. Then, keep [/
1
 on the recorder 
pressed for about ten seconds until 
“WELCOME” appears in the front panel display.
“LOCKED” appears in the front panel display.
, The disc tray is locked. Cancel the Child Lock