Sony SLV-X9G Manuel D’Utilisation

Setting the Set-Top Box

Notes

• If your VCR is connected to the STB by the aerial cable, enter the programme

number of the VCR corresponding to the channel where you have set up the STB
output in step 4.

• You cannot watch programmes from your STB on the TV while recording unless

you record a programme from your STB.

• It is recommended to connect your STB to the LINE-3 IN connector.
• For some STB, in order to avoid any conflict between the STB controller and the

VCR remote commander, be careful not to point the remote commander towards
the STB and the VCR at the same time.

• If POWER SAVE is set to FULL, you cannot watch or record programmes from

your STB during standby mode. Set POWER SAVE in the OPTIONS-2 menu to
OFF or PARTIAL.

• If you connect the STB using the

aerial cable:
Press

M/m/, to select RF and

press OK.
Press

M/m to highlight

PROGRAMME NO. and press
OK. Enter the appropriate number
using

M/m and press OK.

• If you connect the STB using the

Scart (EURO-AV) cable:
Press

M/m/, to select LINE3 and

press OK.

Press

M/m, to highlight STB

BRAND NO. and press OK. Enter
the appropriate number using the
programme number buttons, then
press OK. Refer to the table on page
25 for Set-Top Box brand number.

Press MENU to exit the menu.

PLAY

SET

SELECT :

EXIT

SET-TOP BOX

RF
---
06

STB CONNECTION
STB BRAND NO.
PROGRAMME NO.

RETURN

SET

SELECT :

EXIT

SET-TOP BOX

LINE3
---

STB CONNECTION
STB BRAND NO.

RETURN

PLAY

SET

SELECT :

EXIT

SET-TOP BOX

RF
123
06

STB CONNECTION
STB BRAND NO.
PROGRAMME NO.

RETURN