Panasonic NV-GS25GN Manuel D’Utilisation

Others

LSQT0893

• Remove the cassette and then press the 

[RESET] button. (

) If normal conditions are 

not restored yet, turn off the power. Then, 
about 1 minute later, turn on the power again. 
(Conducting the above operation when the 
access lamp is on may destroy the data on the 
card.) 

6: The cassette cannot be removed.
• Does the power lamp comes on when opening 

the cassette cover? (

) Make sure that the 

battery and the AC adaptor are properly 
connected. (

) 

• Is the battery in use discharged? Charge the 

battery and remove the cassette.

• Close the cassette cover completely, and fully 

open it again. (

) 

• Has condensation occurred? Wait until the 

condensation indication disappears. (

) 

8: The remote control does not function.
• Has the button-type battery of the remote 

control run out? Replace it with a new button-
type battery. (

) 

• Is the setting on the remote control correct? If 

the setting on the remote control is not in 
agreement with the [REMOTE] setting on the 
movie camera, the remote control does not 
operate. (

) 

• Is the accidental erasure prevention slider on 

the cassette open? If it is open (set to [SAVE]), 
recording cannot be performed. (

) 

• Is the tape wound to the end? Insert a new 

cassette.

• Is the recording mode set? When in the 

playback mode, recording cannot be 
performed. (

) 

• Has condensation occurred? No operation 

other than cassette removal can be performed 
when condensation occurs. Wait until the 
condensation indication disappears. (

) 

• Is the cassette cover open? If the cover is 

open, the movie camera may not operate 
normally. Close the cassette cover. (

) 

2: The screen has changed suddenly.
• Has the demonstration started? In the Tape 

Recording mode, if you set [DEMO MODE] >> 
[ON] without inserting a cassette and a card, 
the demonstration starts. For normal use, set 
this function to [OFF]. (

) 

3: A cassette cannot be inserted.
• Has condensation occurred? Wait until the 

condensation indication disappears.

4: Auto focus function does not work.
• Is manual focus mode selected? If auto focus 

mode is selected, focus is automatically 
adjusted.

• There are some recording subjects and 

surroundings for which the auto focus does not 
operate correctly. (

) If so, use the manual 

focus mode to adjust the focus. (

)

• Is the colour night view function set? When the 

colour night view function is working, focusing 
shifts into the manual mode.

• Read the contents and respond to them. 

(

)

2: The time code becomes inaccurate.
0 The time code indication counter may not be 

constant in the reversed slow-motion playback, 
but this is not a malfunction.

• The remaining tape time indication may 

disappear temporarily during frame-by-frame 
playback or other operation. If you continue 
ordinary recording or playback, the indication is 
restored.

• If scenes of less than 15 seconds are 

continuously recorded, the remaining tape time 
cannot be correctly displayed.

• In some cases, the remaining tape time 

indication may show remaining tape time that is 
2 to 3 minutes shorter than the actual 
remaining tape time.

• If you set [SETUP] >> [DISPLAY] >> [OFF], 

indications other than the tape running 
condition, warning, and date indications 
disappear.

GS35_25GN.book  46 ページ  ２００５年１月３１日　月曜日　午後３時２５分