Panasonic nv-gs80ep Manuel D’Utilisation
Before using
9
LSQT1130
ª
Connecting to the AC outlet
The unit is in the standby condition when the AC
adaptor is connected. The primary circuit is
always “live” as long as the AC adaptor is
connected to an electrical outlet.
adaptor is connected. The primary circuit is
always “live” as long as the AC adaptor is
connected to an electrical outlet.
1
Connect the AC mains lead to the AC
adaptor and the AC mains socket.
adaptor and the AC mains socket.
2
Connect the DC input lead to the AC
adaptor.
adaptor.
3
Connect the DC input lead to this product.
≥The output plug of the AC mains lead is not
≥The output plug of the AC mains lead is not
completely connected to the AC adaptor
socket. As shown in
socket. As shown in
1, there is a gap.
≥Do not use the power cord for other
equipment since the power cord is exclusively
designed for the movie camera. Or do not use
the power cord of other equipment for the
movie camera.
designed for the movie camera. Or do not use
the power cord of other equipment for the
movie camera.
ª
Fitting the battery
Push the battery against the battery holder and
slide it until it clicks.
slide it until it clicks.
ª
Removing the battery
While sliding the [BATTERY] lever, slide the
battery to remove it.
battery to remove it.
≥Hold the battery with your hand so it does not
fall.
≥Before removing the battery, be sure to set the
[OFF/ON] switch to [OFF].
1
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to
the manufacturer’s instructions.
incorrectly replaced. Replace only with
the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to
the manufacturer’s instructions.
BATTERY
LSQT1130_ENG.book 9 ページ ２００６年１２月１６日 土曜日 午後８時４５分