Manualsbrain.com
  1. Manuels
  2. Marques
  3. Panasonic
  4. pt vx400ntu
  5. Manuel D’Utilisation

Panasonic pt vx400ntu Manuel D’Utilisation

Télécharger
Page de 86
About Your Projector
20
 - ENGLISH
Preparation
(14) <POINTER> Button
     Act as the On-Off switch for the Pointer. 
(
Æ
page 37)
(15) <PAGE > Buttons
     Scroll back and forth the pages on the screen 
when giving a presentation. To use these buttons,                                                                                                                                         
connect the projector and your computer with a 
USB cable.
(16) <MUTE> Button 
    Mute the sound. (
Æ
page 38)
(17) <D.ZOOM +/-> Buttons
        Zoom in and out the images. (
Æ
page 53)
(18) <FREEZE> Button
        Pauses the projected image and sound 
tentatively. (
Æ
page 39)
(19) <AV MUTE> Button
     Temporarily turn off the image on the screen. 
(
Æ
page 39)
(20) <SCREEN> Button
    Select a screen mode. (
Æ
page 52)
(21) <P-TIMER> Button
    Operate the P-timer function. (
Æ
page 39)
(22) <LAMP> Button
    Select a lamp mode. (
Æ
page 39)
(23) ON/OFF switch
     When using the remote control, set this switch to 
“ON”. Set it to “OFF” for power saving when it is 
not in use.
(24)  Input Selection buttons: <COMPUTER 
1>, <COMPUTER 2>, <HDMI>, <VIDEO>, 
<S-VIDEO>, <NETWORK>. 
   These buttons are used to select the input signal. 
(
Æ
page 38)
(25) <KEYSTONE> Button
   Correct keystone distortion. (
Æ
page 37)
Attention
Do not drop the remote control.
 
z
Avoid contact with liquids.
 
z
Do not attempt to modify or disassemble the remote 
 
z
control.
Note
The remote control can be used within a distance of 
 
z
about 5 m (16.4 ft) if pointed directly at the remote control 
signal receiver. The remote control can control at angles 
of up to ± 30 ° vertically and ± 30 ° horizontally, but the 
effective control range may be reduced.
If there are any obstacles between the remote control 
 
z
and the remote control signal receiver, the remote control 
may not operate correctly.
You can operate the projector by reflecting the remote 
 
z
control signal on the screen. The operating range may 
differ due to the loss of light caused by the properties of 
the screen.
When the remote control signal receiver is lit with a 
 
z
fluorescent light or other strong light source, the projector 
may become inoperative. Set the projector as far from 
the luminous source as possible.
(15)
(24)
(21)
(20)
(22)
(25)
(18)
(14)
(17)
(19)
(16)
(23)