Panasonic PT-AX100U Manuel D’Utilisation

When installing the projector, select the projection 
method according to the projector position. Press 

I H

to cycle through the options. See “Projection method” 
on page 15.

You can select the required duration of time and set the 
off timer to turn off the POWER of the projector 
automatically. 3 minutes before turn-off, the countdown 
of minutes will be displayed in the lower right corner. 
Press

I H to cycle through the options. See “Switching 

off the projector automatically” on page 23.

If you use the projector at high elevations, set the fan 
speed to HIGH. Press 

I H to select HIGH or LOW.

You can adjust the power of the lamp to save on 
electricity, prolong the lamp life and reduce the noise.

You can check how long time has been the lamp used.

You can use the 2 different of test pattern to adjust the 
focus of the image. The PICTURE MODE is switched to 
DYNAMIC temporarily, and return to the last used 
setting when return to projection.

1. Press ENTER to display test pattern 1 and adjust 

the focus with the Focus ring.

2. Press ENTER to display test pattern 2 and adjust 

the focus with the Focus ring again.

3. Press MENU or RETURN to return to the previous 

menu, or press repeatedly to return to the screen.

Setting on a desk/floor and 
projecting from front 

Mounting in the ceiling and 
projecting from front

Setting on a desk/floor and 
projecting from rear

Mounting in the ceiling and 
projecting from rear

NOTE:
  At 1 400 m (4593 ft) above sea level, the setting 

must be HIGH.

When higher luminance is 
required such as movies

When lower luminance is 
sufficient such as in a small room

NOTE:
  When no input signal is detected, the function is 

disabled.

NOTE:
  LAMP RUNTIME is a relevant matter for lamp 

replacement timing. See “Care and Replacement” 
on page 37.

NOTE:
  While a test pattern is displayed, the PICTURE

MODE is changed temporarily to DYNAMIC.

  When the projector and/or the screen is tilted, 

adjust the focus at the center of the image. The 
upper and lower edge might be out of focus.

  When the image is distorted in keystone, adjust 

the KEYSTONE in POSITION menu.