Panasonic tc-21p50r Manuel D’Utilisation
21
Tuning Procedure
5
6
+
If the sound is not clear or no
s o u n d i s p r o d u c e d o n a
Position Number Position,
push the Volume Up “+” or
Down “
s o u n d i s p r o d u c e d o n a
Position Number Position,
push the Volume Up “+” or
Down “
−
” button.
Push the “PRE.” (preset)
button 5 times.
button 5 times.
Helpful Hint
(1) If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the “Colour System
Selection” operation on page 29.
(2) After the Manual tune is finished, push the Position Number “
∧
” button to confirm the tuning condition for each
Position Numbers. If some Position Numbers are unused, it is possible to skip such Position Numbers. Please
refer to the Position Number skip operation on page 24.
refer to the Position Number skip operation on page 24.
(3) When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable as
indicated in the instruction manual of VCR and to set the designated channel to position No. “0”. In that case,
perform manual tune after setting the colour system and sound system in advance. Further, in multi-system VCR,
it is more convenient to set the designated channel to several Position Numbers.
perform manual tune after setting the colour system and sound system in advance. Further, in multi-system VCR,
it is more convenient to set the designated channel to several Position Numbers.
Yo u m a y i m p r o v e t h e
Sound quality.
The sound indicator will
change as follows.
Sound quality.
The sound indicator will
change as follows.
Note:
When sound volume is too
small to confirm, turn it up
by using the sound volume
b u t t o n o n t h e r e m o t e
control.
When sound volume is too
small to confirm, turn it up
by using the sound volume
b u t t o n o n t h e r e m o t e
control.
This returns the set to the
normal viewing condition.
normal viewing condition.
4.5MHz
6.5MHz
5.5MHz
6.0MHz
PRE.