Panasonic tx-36pd30 Manuel D’Utilisation

Example 2

Example 1

This TV set is designed to operate on 220

240V, 50Hz A.C.

To prevent fire, never place any type of candle or naked

flame on top of, or near the TV set.

To prevent damage which might result in electric shock or

fire, do not expose this TV set to rain or excessive moisture.

This TV must not be exposed to dripping or splashing water

and objects filled with liquid, such as vases, must not be

placed on top of or above the TV.

WARNING : HIGH VOLTAGE !!!

Do not remove the rear cover as live parts are accessible

when it is removed. There are no user serviceable parts

inside.

TV Games / Home Computers

Extended use of TV games or home computers with any

television set can cause a permanent ‘shadow’ on the

screen.Thistypeofirreversiblepicturetubedamage,canbe

limited by observing the following points:

Reduce the brightness and contrast levels to a minimum

viewing level.

Do not operate the television set for a continuous period

of time while using TV games or home computers.

This type of picture tube damage, is not an operating

defect, and as such is not covered by the Panasonic

warranty.

The On/Off switch on this model does not fully disconnect

the TV from the mains supply. Remove the mains plug from

the wall socket before connecting or disconnecting any

leads or if the TV set is not used for a prolonged period of

time.

Note:

If the set is not switched off when the TV station stops

transmitting, it will automatically go to standby mode

after 30 minutes. This function will not operate when the

TV is in AV mode.

Cabinet and picture tube care

Remove the mains plug from the wall socket. The cabinet

and picture tube can be cleaned with a soft cloth moistened

with mild detergent and water. Do not use solutions

containing benzol or petroleum. TV sets can produce static

electricity, care must be taken whenever touching the TV

screen.

Adequate ventilation is essential to prevent failure of

electrical components, we recommend that a gap of at least

5cm is left all around this television receiver even when it is

placed inside a cabinet or between shelves.

Avoid exposing the TV set to direct sunlight and other

sources of heat. To prevent fire, never place any type 0f

candle or naked flame on top or near the TV set.

FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY

This appliance is supplied with a fitted three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. If

the fuse is replaced then the replacement fuse must be 5 amp rated and should be approved by ASTA or BSI to BS1362.

Check for the ASTA mark

ASA

or the BSI mark

on the body of the fuse.

Ifthefittedplughasaremovablefusecoveryoumustensurethatitisrefittedwhenthefuse

isreplaced.Ifyoulosethefusecovertheplugmustnotbeuseduntilareplacementcoveris

obtained. Replacement fuse covers can be purchased through your local Panasonic

dealer.

The plug fitted to this appliance incorporates a mains filter circuit. If this is removed

or replaced with a non

filtered plug this television will no longer meet the European

standardsforElectromagneticCompatibility(EMC).Ifthefittedplugisunsuitablefor

the socket outlet in your home an appropriate adapter should be used.

Nonetheless, if the fitted plug is replaced, the fuse should be taken out and the

cut

off plug disposed of safely. There is danger of severe electrical shock if the cut

off plug is inserted into any 13 amp socket.

If a new plug is to be fitted please observe the wiring code as shown below.

If in any doubt please consult a qualified electrician.

How to replace the fuse (for plug type shown in example 1) :

Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refit

securely into the mains plug (see example 1).

How to replace the fuse (for plug type shown in example 2) :

Liftopenthefusecompartment,inthemainsplug,withascrewdriver,andreplacethefuse,

then press the fuse cover down securely (see example 2).

IMPORTANT :

The wires in the mains lead of this appliance are coloured in accordance with the following code :

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your

plug, proceed as follows :

The BLUE wire must be connected to the terminal marked ‘N’ or coloured black.

The BROWN wire must be connected to the terminal marked ‘L’ or coloured red.

IMPORTANTNOTE:UndernocircumstancesshouldeitherofthesewiresbeconnectedtotheEarthterminalofthethreepinplug,

marked with the letter ‘E’ or the earth symbol.

Warnings and precautions