Toshiba 32a61 Manuel D’Utilisation

Using the

Remote Contr

Programming the remote control for use
with a VCR or cable TV converter

The remote control provided with your Toshiba TV is preprogrammed
to operate Toshiba VCRs also.
To operate non-Toshiba components using
the remote control provided with your TV:

1. Refer to the VCR and cable TV converter code table below to

find the corresponding code for your VCR or cable TV converter
brand.
If more than one code is listed, try each one separately until you
find the one that works.

2. If you are reprogramming the remote control to operate your:

• VCR: Set the TV/CABLE/VCR switch on the remote control

to VCR.

• Cable TV converter: Set the TV/CABLE/VCR switch on the

remote control to CABLE.

3. Hold down the RECALL button while using the Channel

Number buttons to enter the three-digit code of your VCR or
cable TV converter brand.

4. Point the remote control at the VCR or converter and press

POWER to test the code.
• If the VCR or converter turns on, you have entered the

correct code.

• If the VCR or converter does not respond to the remote

control, you may have entered the incorrect code.
Repeat steps 1–4 using another code.

5. Reset the TV/CABLE/VCR switch to TV to control the TV.

For future reference, write down the codes you used:
VCR code

_____________________

Cable TV converter code _____________________

Note:
•

When the batteries are replaced, the
remote control must be reprogrammed.

•

Some VCRs can use either of two remote
control codes. These VCRs have a switch
labeled “VCR1/VCR2.” If your VCR has this
kind of switch and does not respond to any
of the VCR codes, set the switch to the
other position (VCR1 or VCR2) and
reprogram the remote control.

CH RTN

ADV/

PIP CH

LIGHT

MUTE TV/VIDEO TIMER

RECALL POWER

CABLE

VCR

ENT

ENTER

FAV

CAPT

100

Channel
Numbers

TV/CABLE/VCR
switch

ENT (used for the “ENTER”
command with some VCRs
and cable TV converters)

POWER

CH (Channel)

VOL

RECALL