Toshiba brst-10 Manuel D’Utilisation

7-1

EO1-13013

POWER

FEED

RESET

CART-

RIDGE

SLIP

INKOUT

POWER

ERROR

or

7. REPLACING THE INK CARTRIDGE

2. Depress the [CARTRIDGE] switch for 3 seconds.

By this operation, the carriage moves to the head unit/ ink
cartridge replacement position.
NOTES: 1. If the printer cover is closed, the carriage will

not move to this position by this operation.

2. Never perform this operation except for the

ink cartridge replacement.

3. While pushing the hook in direction 

1

, remove the ink cartridge from the head unit in diretion 

2

.

Fig. 7-1

Carriadge

Fig. 7-2

Ink Cartridge

Hook

2

1

The INKOUT LED on or blinking  shows that ink is getting
low.  The printer can print until ink is fully finished, however,
please replace the ink cartridge with a new one earlier.

1. To avoid injury and printer damage, be careful not to catch your fingers or any objects while

the carriage moves right and left in the initial performance.

2. Please be careful when handling ink cartridges, not to get ink on your hands or in your eyes.

If you accidently get ink on your hands wash them with soap and water.  If any ink should get
into your eyes immediately flush them out with clear water.

1. Do not put anything on the printer cover and never press on it.
2. Do not drop or shake the head unit/ ink cartridge.  Doing so may cause ink to spill over.  Once

ink gets on your clothes, it cannot be removed.

1. Remove the printer cover. (Refer to 5.2 LOADING THE HEAD UNIT/ INK CARTRIDGE.)

POWER

FEED

RESET

CART-

RIDGE

SLIP

INKOUT

POWER

ERROR

or