Toshiba m700-m710 Manuel D’Utilisation

User’s Manual

C-1

In most cases, you will not need to type AT commands manually. However, 
there might be some occasions when you will need to do so.

This chapter describes AT commands for data mode. Fax and voice 
commands are taken care of by application software.

The format for entering AT commands is:

where X is the AT command, and n is the specific value for that command. 
After you type in the command press ENTER.

Any command issued is acknowledged with a response in either text or 
numeric values known as result codes.

All commands and command-values accepted by the modem are 
described in this section; any entry other than those listed results in an 
error.

The escape sequence allows the modem to exit data mode and enter on-
line command mode. While in on-line command mode, you can 
communicate directly to your modem using AT commands. Once you 
finish, you can return to data mode using the ATO command.

A pause, the length of which is set by Escape Guard Time (S12), must be 
completed after an escape sequence is entered. This pause prevents the 
modem from interpreting the escape sequence as data.

The value of the escape sequence character may be changed using 
register S2.