Toshiba portege r500 Manuel D’Utilisation

188

Hot swapping (removing one PC Card and inserting another 
without turning the computer off) fails.

Follow this procedure before you remove a PC Card:

Double-click the Safely Remove Hardware icon in the 
System tray.

Select the item you wish to remove.

Click Stop.

Remove the device when prompted to do so.

Click OK three times to close the Safely Remove Hardware 
screen.

Never swap modules when the computer is in Hibernation or 
Standby mode. This is known as “warm swapping” and is not 
supported. For more information on Hibernation and Standby modes 
see 

 and 

The system does not recognize your PC Card.

Refer to the PC Card documentation.

Removing a malfunctioning card and reinstalling it can correct 
many problems. 

Reinsert the card to make sure it is properly connected.

If the card is attached to an external device, check that the 
connection is secure.

Refer to the card’s documentation, which should contain a 
troubleshooting section.

This section lists some of the most common printer problems.

Check that the printer is connected to a working power outlet, 
turned on and ready (on line).

Check that the printer has plenty of paper. Some printers will not 
start printing when there are just two or three sheets of paper left in 
the tray.

Make sure the printer cable is firmly attached to the computer and 
the printer.