Toshiba portege 610ct 620ct Instruction De Maintenance
3-20
610CT
3.8
Floppy Disk Test
CAUTION: Before running the floppy disk test, prepare a formatted work disk.
Remove the Diagnostics Disk and insert a work disk into the FDD. The contents
of the floppy disk will be erased.
Remove the Diagnostics Disk and insert a work disk into the FDD. The contents
of the floppy disk will be erased.
To execute the Floppy Disk Test, select 5 from the DIAGNOSTIC TEST MENU, press
Enter and follow the directions displayed on the screen. The Floppy Disk test contains five
subtests that test the 610CT external floppy disk drive. The following messages will appear
after selecting the Floppy Disk Test from the DIAGNOSTIC TEST MENU. Answer each
question with an appropriate response to execute the test.
Enter and follow the directions displayed on the screen. The Floppy Disk test contains five
subtests that test the 610CT external floppy disk drive. The following messages will appear
after selecting the Floppy Disk Test from the DIAGNOSTIC TEST MENU. Answer each
question with an appropriate response to execute the test.
1.
Select the test drive number of the floppy disk drive to be tested and press Enter.
Test drive number select (1:FDD#1,2:FDD#2,0:FDD1&2) ?
2.
Select the media type of the floppy disk in the test drive to be tested, and press
Enter.
Enter.
Media in drive #X mode (0:2DD,1:2D,2:2D-2HD/2DD,3:2HD) ?
3.
Select the track you want the test to start on and press Enter. Simply pressing
Enter sets the start track to zero.
Enter sets the start track to zero.
Test start track (Enter:0/dd:00-79) ?
4.
The floppy disk test menu will appear after you select the start track number.
Select the number of the subtest you want to execute and press Enter. The
following message will appear during the floppy disk test.
Select the number of the subtest you want to execute and press Enter. The
following message will appear during the floppy disk test.
FLOPPY DISK
XXXXXXX
PORTÉGÉ 610CT DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] ; test end
[Ctrl]+[C] ; key stop
[Ctrl]+[C] ; key stop
SUB-TEST : XX
PASS COUNT: XXXXX ERROR COUNT: XXXXX
WRITE DATA: XX READ DATA : XX
ADDRESS : XXXXXX STATUS : XXX
The first three digits in the ADDRESS number indicate which cylinder is being
tested. The fourth digit indicates the head, and the last two digits indicate the
sector being tested.
tested. The fourth digit indicates the head, and the last two digits indicate the
sector being tested.
The first digit in the STATUS number indicates the drive being tested and the last
two digits indicate the error status code as explained in table 3-3.
two digits indicate the error status code as explained in table 3-3.