Toshiba portege 610ct 620ct Instruction De Maintenance
3-26
610CT
3.11 Hard Disk Test
To execute the Hard Disk Test, select 8 from the DIAGNOSTIC TEST MENU. Press
Enter, and follow the directions displayed on the screen. The hard disk test contains 10
subtests that test the 610CT hard disk drive functions. The following messages will appear
after selecting the hard disk test from the DIAGNOSTIC TEST MENU. Answer each of the
following questions with an appropriate response to execute the test:
Enter, and follow the directions displayed on the screen. The hard disk test contains 10
subtests that test the 610CT hard disk drive functions. The following messages will appear
after selecting the hard disk test from the DIAGNOSTIC TEST MENU. Answer each of the
following questions with an appropriate response to execute the test:
CAUTION: The contents of the hard disk will be erased when subtest 02, 03, 04, 05, 06,
08, 09, or 10 is executed. Before running the test, transfer the contents of the hard disk
to a floppy disk(s). This can be done with the Toshiba MS-DOS BACKUP command.
08, 09, or 10 is executed. Before running the test, transfer the contents of the hard disk
to a floppy disk(s). This can be done with the Toshiba MS-DOS BACKUP command.
After the hard disk test is completed, execute the Toshiba MS-DOS FDISK command,
which will set the partition. Next, execute the Toshiba MS-DOS FORMAT command.
Refer to the Toshiba MS-DOS manual for details.
which will set the partition. Next, execute the Toshiba MS-DOS FORMAT command.
Refer to the Toshiba MS-DOS manual for details.
1.
When you select the hard disk test from the DIAGNOSTIC TEST MENU, the
following message will appear:
following message will appear:
Test drive number select (1:HDD#1,2:HDD#2,0:HDD1&2) ?
2.
Select the hard disk drive number to be tested and press Enter. The following
message will appear:
message will appear:
HDC F/W error retry (1:yes,2:no) ?
3.
This message is used to select the retry operation when the hard disk controller
detects an error. Select 1 or 2 and press Enter. The following message will
appear:
detects an error. Select 1 or 2 and press Enter. The following message will
appear:
Data compare error dump (1:no,2:yes) ?
4.
This message is used to select the error dump operation when a data compare
error is detected. Select 1 or 2 and press Enter. The following message will
appear:
error is detected. Select 1 or 2 and press Enter. The following message will
appear:
Detail status display (1:no,2:yes) ?
5.
This message is used to select whether or not the HDD status is displayed on the
screen. The HDD status is described in section 3.15. Select 1 or 2 and press
Enter.
screen. The HDD status is described in section 3.15. Select 1 or 2 and press
Enter.