Toshiba scale view v4 Manuel D’Utilisation

Scale View V4.0 Owner’s Manual

Scheduled Batches

18-Oct-04

Page 17

Delete Multiple PLU’s

To delete multiple PLU’s for a department follow the Windows

Task Scheduler instructions for

adding a task and add the command line switch as shown.

delete,1

The 1 is fixed. (department information is included in the “delete.txt” file.) There is a space
between the “ mark and delete.

To delete multiple PLU’s in the department you will need to create a file named “delete.txt”. The
“delete.txt” file can be created using Windows

Notepad. The PLU’s you want to delete should

be added to the file by entering the department number, PLU number then pressing the enter
key.

Ex.)

1,1001
1,1002
1,3010
1,5005
1,6000

At the end of each PLU number the enter key was depressed. After all the PLU’s you wish to
delete are entered save the file as “delete.txt” in C:\Program Files\ScaleView\FTP.

Note: The path shown is the location if you used the default directory during the Scale
View installation procedure. If you did not use the default directory when installing Scale
View you will need to save the “delete.txt” file in the FTP folder located in the path where
you installed Scale View. If the “delete.txt” file is not located in the correct folder it will not
be executed and the PLU’s you wanted to delete will not be deleted.

Executing this command will result in all PLU numbers included in the “delete.txt” file being
deleted from the database and all departmental scales if there are not any communications
problems. (i.e., scale turned off, scale disconnected from the network, etc.) If there are any
problems with communications to any scale in the department the PLU’s will not be deleted from
the database. The PLU’s will be deleted from any scale that had successful communications.