Toshiba st-60 Manuel D’Utilisation

EO1-12026

9-1

9.  TROUBLESHOOTING

If you cannot solve a problem with the following solutions, do not attempt to repair it by yourself.
Turn the power off, unplug the POS Terminal, then contact your TOSHIBA TEC representative for
assistance.

The power does not turn

•

Is the power cord plugged in correctly?

•

Plug in correctly.

on.

•

Is the power supplied to the AC outlet?

•

If it is not a power
failure, check
for the power supply to
the AC outlet with
another electric appli-
ance. When the power
is not supplied, contact
your nearest power
company.

•

Has the fuse of power supply unit or circuit

•

Check the fuse or circuit

breaker blown?

breaker.

The operator’s display is

•

Does the operator’s display reflect sunlight

•

Refer to page 5-1 and

hard to see.

or room light?

adjust the display angle.

•

Is the tilt angle adjusted properly?

•

Is the brightness ad justed properly?

•

Refer to page 5-1 and
adjust the brightness
properly.

Floppy disk drive cannot

•

Is the floppy disk drive (FDDST-60-1-QM)

•

Turn the ST-60 power

be used.

connected properly?

OFF, and then connect
the floppy disk drive
again.

Any data cannot be written

•

Is the floppy disk write protected?

•

Eject the floppy disk

into the floppy disk.

and cancel the write
protect.  Refer to page
6-1.

•

Is the floppy disk formatted properly?

•

Format the floppy disk
properly.

•

Is the memory insufficient?

•

Delete unnecessary
data or prepare a new
floppy disk.

Magnetic card reader does

•

Does the used card comply with the

•

Use Track 1, 2 comply-

not read the data.

standard?

ing with ISO1.

•

Was the card moved too fast or too slowly?

•

Move the card at the
proper speed.
(10~150cm/sec.)

•

Is the card reading direction correct?

•

Insert the card so that
the magnetic strip faces
the scanning head.

No sound

•

Is the speaker volume turned down?

•

Adjust the speaker
volume with the
speaker volume control
properly.