Toshiba t 720 Manuel D’Utilisation

29

28

MENU / ENTER

● To operate via the remote control’s           buttons, [PJ MODE] must be

selected. Press the PJ Mode button. The button lights up. This light will go out 30
seconds after operations are complete. If necessary, press the button again.

■ Using auto setting (Auto setting)

This function sets up the projector to the optimum state for
each type of the input signal by using simple operations.

The Auto setting menu appears.

The menu item is automatically adjusted/set.
For computer input, the 

 icon will appear during

processing.

• Auto adjustment/setting may not be performed correctly for input signals other than

those supported by the projector 

, 

.

● Manual adjustment and setting

The menu items vary according to the input type, as shown in the table below.
Use the 

 

 

 

 

 buttons to adjust the items in the table below, then press

the 

 button when you are finished. The menu disappears.

Adjust with           to eliminate flicker.

Adjust with            to eliminate periodic patterns and 
flickering when many vertical lines appear in the screen.

Move left           Move right

Move up            Move down

Adjust with           to eliminate flicker.

Input

Item

Description

Select Item

Select Item

Signal format [     : Enter to setting mode]    [          : Select one 

of the following]    [Apply:     ]
480i(525i)@60Hz/480p(525p)@60Hz/

[     : Enter to setting mode]    [          : Select one 
of the following]    [Apply:     ]

 

Set to local line frequency: 50Hz           60Hz

1

2

3

1

2

The placement angle and the height of the projected image can be adjusted by the foot
adjuster.

q Lift up the front of the projector until

The foot adjuster extends. Release the
button to lock the position.

w Turn the foot adjuster to fine-tune

e To adjust the horizontal angle, use

To stow the foot adjuster, hold up the projector while pressing the foot adjuster
release button, then slowly lower the projector will the button depressed.

q Use the zooming lever to adjust the screen

w Use the focusing ring to adjust the focus.

The speaker volume can be adjusted when an audio signal is being input.

• Note that the lamp characteristics may rarely cause the brightness to fluctuate slightly.
• A lamp is consumable supplies.

If used for extended periods, images will appear dark, and the lamp could burn out.  This
is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on
conditions of use.)

• The LCD panel is made using extremely advanced technology, but there may be black

spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the panel.
Please note that these are not malfunctions.

• Although this projector supports a wide range of RGB signals 

, any resolutions not

supported by the model (XGA or SVGA, depending on the model) will be expanded or
shrunk, which will affect image quality slightly. To view high-quality images, it is
recommended that the computer’s external output should be set to the projector’s
resolution.

• With some models of computer having LCD displays or the like, displaying images

simultaneously on the projector and the monitor’s display may prevent the images from
displaying properly. If this happens, turn off the computer’s LCD display. For information
on how to turn off the LCD display, see the owner’s manual of your computer.

• If a signal not supported by the projector is input, the 

 icon will appear.

• If a no signal is being input from the connected device, the 

 icon will appear.

• If an unavailable operation button is pressed, the 

 icon will appear.