Toshiba t 720 Manuel D’Utilisation

53

52

You can call up on-screen menus, and conduct a number of adjustments and settings,
using the operation buttons 

 on the control panel (main unit side) and remote control.

■ How to use the menus

The menu shown below is only for operation instructions and might be different from
the actual display.

• Menu adjustments and settings  (except Lamp power 

) are saved when the power is

turned off via the ON/STANDBY button. If the power cord is unplugged before this, or the
power goes out, then the data will not be saved.

Display the Setting display menu

To Status display

The menu disappears

Finish via the Status 
display menu.

Select a category by using           .

There are following four 
categorys.

Displays the current 
adjustments of selected 
category.
Item shown with gray 
cannot be adjusted for the 
current input source.

PC card setting menu

Image adjustment menu

Default setting menu

Display setting menu

The figure shows a typical example.  
As the display may differ depending 
on the item, use the following pages 
as a reference.

Item

Adjustment/Setting Value

This mark signfy that 
there are options.
Press        to display a 
list of options.

These marks signify the 
items can be adjusted/set 
by using                .

These marks signify an 
item can be switched by 
using                .

These marks signify the items can be selected from 
the list by using            .
After an item selected, apply it by pressing      .

Press      to open the menu 
of the selected category.

MENU / ENTER

A computer can be operated using the projector’s remote control.  This function is available
on any computer with the Windows 98/98SE, Windows Me, Windows 2000, or Windows XP
OS, that is equipped with a USB port which can support USB1.1 (The mouse remote
control receiver is also supported on OS 9 or OS X for the Macintosh).  However, please
note that Toshiba does not guarantee the operation of all computers.

Connect the projector to a computer using the supplied USB cable. See Fig. (1) below.
For models equipped with PC card slot, connect the supplied Mouse remote control
receiver to the computer. See Fig. (2) below.

(2)

(1)

The mouse remote control function is available when the remote control is set to [PC
Mode]. (See “Switching operation modes” 

.)

Point the remote control at the infrared remote sensor (in models using Mouse
remote control receivers, point it at the Mouse remote control receiver), and
operate the remote control’s buttons.
● Moving the mouse pointer

Move the pointer control button in the direction that you wish the mouse pointer to

move, then press.

● To left click

Press the L-CLICK button.

● To right click

Press the R-CLICK button.

● To drag and drop

Move the pointer control button in a (L-)clicked state, then when the pointer is over

the desired location, release the button.

● Using the computer’s up and down arrow key functions

Press the 

 and 

 buttons to switch PowerPoint

®

 slides.