kymco mo d200 Instruction De Maintenance

16

. BATTERY/CHARGING SYSTEM

16-4

BATTERY

Remove the seat and met-in box. (2-3)

Remove the battery cover screw and the

battery cover.

Remove the battery.

First disconnect the battery negative (-) cable

and then the positive (+) cable.

The installation sequence is the reverse of

removal.

BATTERY VOLTAGE INSPECTION (OPEN

CIRCUIT VOLTAGE)
Disconnect the battery cables.

Measure the voltage between the battery

terminals.

Fully charged : 13.2V

Undercharged : 12.3V max.

CHARGING
Connect the charger positive (+) cable to the

battery positive (+) terminal.

Connect the charger negative (-) cable to the

battery negative (-) terminal.

Charging current : Standard : 0.9A

Quick

: 4A

Charging time

: Standard : 5_

10 hours

Quick

: 30 minutes

After charging: Open circuit voltage: 12.8V min.

Battery Cover Screw

When disconnecting the battery positive

(+) cable, do not touch the frame with

tool; otherwise it will cause short circuit

and sparks to fire the fuel.

•

Keep flames and sparks away

from a charging battery.

•

Turn power ON/OFF at the

charger, not at the battery terminals to

prevent sparks near the battery.

•

Charge the battery according

 

to

the current specified on the battery.

•

During quick charging, the battery

temperature should not exceed 45℃ .

• Quick charging should only be done in

an emergency.

• Measure the voltage 30 minutes after

the battery is charged.

＊

Battery charging inspection must be

performed with a voltmeter.

＊

First connect the positive (+) cable and then

negative (-) cable to avoid short circuit.