buell s1 lightning '97 Manuel
2-13
INSTALLATION
1.
Place wheel centrally in the swingarm with the brake
rotor in the caliper. Slide wheel far enough forward to slip
belt over sprocket and then slide wheel back.
rotor in the caliper. Slide wheel far enough forward to slip
belt over sprocket and then slide wheel back.
2.
See
CANT to axle (3).
3.
Insert axle (3) through washer (4), left side of swingarm,
rear brake caliper mount, wheel assembly, spacer (11)
and right side of swingarm.
rear brake caliper mount, wheel assembly, spacer (11)
and right side of swingarm.
4.
Install washer (12), lockwasher (13), and axle nut (14)
(metric) on right side of axle. Do not fully tighten rear axle
nut at this time.
(metric) on right side of axle. Do not fully tighten rear axle
nut at this time.
5.
Install rear brake caliper. See
.
6.
Check for proper belt tension and wheel alignment. See
REAR BELT DEFLECTION
in Section 1.
7.
Tighten rear axle nut (14) (metric) to 66-73 ft-lbs (89.5-
98.9 Nm).
98.9 Nm).
8.
Install rear fender. See
FENDERS, REMOVAL/INSTAL-
LATION
on
page 2-54
.