kymco mo kxr 50 Instruction De Maintenance

Set the rod-end (steering column side) in an

angle where the indentation surface of the

tie-rod is parallel to the rod-end shaft, and

then tighten the lock nut.
Torque: 2.0_ 3.0kgf-m

Set the other rod-end (knuckle arm side) in

an angle as shown (right-hand tie-rod and

left-had tie-rod), and then tighten the lock

nut.
Rod-end (tie rod) angle (A): 15

º

±3

º

 Torque: 2.0_ 3.0kgf-m

INSTALLATION
Install the tie-rod and tighten the nuts.
Torque: 2.5_ 3.5kgf-m

Install the cotter pins and band ends of

cotter pin.

Refer to the “TOE-IN ADJUSTMENT”

section in the CHAPTER 3 to adjust toe-in.

After making adjustment on both tie rods
be sure to mark them R and L for
identification.

The threads on both rod-end must be of
the same length.

To  Knuckle  Arm

Be sure that the rod-end on the

indentation surface side is connected to

the steering knuckle.

Indentation  Surface

Always use a new cotter pin.

(Right Side)

(Left Side)

To  Knuckle  Arm

(A)

(A)