kymco mo kxr 50 Instruction De Maintenance

Check the movable driven face for wear or

damage.

Measure the movable driven face I.D.
Service Limit: 34.06mm over

DRIVEN PULLEY FACE BEARING
REPLACEMENT
Drive the inner needle bearing out of the

driven pulley face.

Remove the snap ring and drive the outer

bearing out of the driven face.

Bearing Puller   E037

Apply grease to the outer bearing.

Drive a new outer bearing into the driven face

with the sealed end facing up.
Seat the snap ring in its groove.

Apply grease to the driven face bore areas.

Press a new needle bearing into the driven

face.

Oil Seal And Bearing Install   E014

Inner Needle Bearing

Outer Bearing

Discard the removed bearing and replace

with a new one.

Discard the removed bearing and replace

with a new one.

Snap Ring

Snap Ring

Outer Bearing

Inner Needle Bearing

Special

Pack all bearing cavities with proper

grease.
Specified grease: Heat resistance 230°C

Special