kymco mo super 950 Instruction De Maintenance

LUBRICATION SYSTEM
《

Oil  Filter  Cleaning》

Disconnect the oil tube at the oil pump side

and allow oil to drain into a clean container.

Remove the tube clip at the oil tank side and

disconnect the oil tube.

Remove the oil filter.

Clean the oil filter screen with compressed

air.

Install the oil filter in the reverse order of

removal and fill the oil tank with specified oil

up to the proper level.

Bleed air from the oil pump and oil lines.

《

Oil Pump Condition》

Open the throttle valve fully and check that

the index mark on the pump body aligns with

the aligning mark on the oil pump control

lever.

Reference tip alignment within 1mm of index

mark on open side is acceptable.

Start and idle the engine, then slowly open

the throttle to increase engine rpm and check

the operation of the oil pump control lever.

If adjustment is necessary, adjust the oil

pump control cable by loosening the control

cable lock nut and turning the adjusting nut.

After adjustment, tighten the lock nut.

If the oil pump is not synchronized properly,

the following will occur:
• Excessive white smoke or hard starting due

to pump control lever excessively open

•Seized piston due to pump control lever

insufficiently open

Oil Filter

Clip

• Connect the oil tubes securely.
• Install the tube clip at the oil tank side

and also install the clip to the lower oil

tube that goes to the oil pump.

• Check for oil leaks.

＊

Adjust oil pump control cable after the

throttle grip free play is adjusted.

＊

Reference tip alignment within 1mm of

index mark on open side is acceptable.

However, the aligning mark on the

control lever must never be on the closed

side of the index mark, otherwise engine

damage will occur because of insufficient

lubrication.

＊

Filter Screen

Pump Body Index

Mark

Adjusting Nut

Lock  Nut

Control Lever Aligning Mark