BMW serie 7 1999 Manuel D’Utilisation
148
n
Oil for power steering/Level control system
*
Vehicle Identification Number
Power steering
With the engine off, unscrew the reser-
voir cap and remove the cap with dip-
stick. Then push the dipstick into the
reservoir again.
voir cap and remove the cap with dip-
stick. Then push the dipstick into the
reservoir again.
The fluid level should be in between the
marks on the dipstick.
marks on the dipstick.
Screw the reservoir cap back on.
Contact your BMW center if the fluid is
low, as only ATF may be used and spe-
cial knowledge is required for topping
up.
low, as only ATF may be used and spe-
cial knowledge is required for topping
up.
380de078
Power steering/Level control
system
system
*
With the engine shut off, loosen the
knurled nut and remove the reservoir
cap.
knurled nut and remove the reservoir
cap.
With the vehicle empty, the fluid level
should be barely 0.2 in (5 mm) above
the screen bottom.
should be barely 0.2 in (5 mm) above
the screen bottom.
Correct the fluid level if required. Al-
ways use Pentosin CHF 11S.
ways use Pentosin CHF 11S.
Position the reservoir cap and tighten
the knurled nut. Make sure the cover is
properly seated.
the knurled nut. Make sure the cover is
properly seated.
380de079
In the engine compartment, stamped on
the right-hand strut dome (arrow) and
on the upper edge of the instrument
panel on the left side.
the right-hand strut dome (arrow) and
on the upper edge of the instrument
panel on the left side.
380de074
Online Edition for Part-No. 01 41 9 791 187 - © 12/98 BMW AG