BMW serie 7 1999 Manuel D’Utilisation

Check Control

Priority 2

These alerts for problems are reported
for 20 seconds when the ignition key is
in position 2. The status reports remain
after the message disappears. You can
view the message again by pressing the
CHECK button.

> TRUNK LID OPEN

This message is given only when ini-
tially starting off.

> DOOR OPEN

This is displayed after a minimum
vehicle speed is exceeded.

> FASTEN SEAT BELTS

In addition, the indicator lamp with
the safety belt symbol appears and
an acoustic signal is heard.

> WASHER FLUID LOW

The washer fluid is too low. Top up
the fluid at the earliest opportunity.
Refer to page

142

> CHECK ENGINE OIL

Add engine oil as soon as possible.
Refer to page

143

> OUTSIDE TEMPERATURE 247

(–5.06)
This display is only an example. The
current reading appears at an outside
temperature of 37.57 (+36) and
below. Refer also to page

> TIRE PRESSURE SET

The RDC has imported the current in-
flation pressure in the tires as the tar-
get values which the system will
monitor.
Refer to page

> CHECK TIRE PRESSURE

Check and correct the tire inflation
pressure to specifications at the earli-
est opportunity (next stop for fuel).
Refer to page

> TIRE CHECK INACTIVE

A temporary interference of the RDC
or a system fault. Refer to page

> BRAKE LAMP CIRCUIT

A bulb has failed or the circuit has a
malfunction. Refer to pages

163

176

or consult an authorized BMW center.

> CHECK LOWBEAMS

CHECK SIDE LAMPS
CHECK REAR LAMPS
CHECK FRONT FOGLAMPS
CHECK LICPLATE LAMP
CHECK TRAILER LIGHTS
CHECK HIGHBEAMS
CHECK BACKUP LAMPS
Defective bulb or circuit. Refer to
pages

163

176

or consult an autho-

rized BMW center.

> TRANS. FAILSAFE PROG

Please consult the nearest authorized
BMW center. Refer to pages

> CHECK BRAKE LININGS

Have the brake pads inspected by
your BMW center. Refer to page 126.

> REMOTE KEY BATTERY

Change the battery. Refer to
page

168

> CHECK COOLANT LEVEL

The coolant is too low. Top up at the
next opportunity. Refer to page

146

> ENGINE FAILSAFE PROG

Fault in the Electronic Engine Power
Control EML. When braking, higher
brake application pressure may be
necessary and brake pedal travel may
be significantly longer.
Please have the system inspected by
your authorized BMW center.